For our healthy house, we used aluminum double-pane windows
with a thermal break. The thermal break is important not only
from an energy efficiency standpoint, but also because it reduces
cold spots on the inside, thereby limiting condensation and the
resulting mold growth. The windows we selected were made by Milgard.
The windows were installed after the roof was enough in place to protect them
from further rain. The installation began by attaching builders foil to the
framing surrounding the window opening with Polyken
aluminum tape. Then a bead of 100% silicone caulk was applied around the perimeter
of the window opening, on top of the foil. The foil would become part of the
wind barrier on the outside of building, under the siding. After the caulk was
applied, the windows were attached to the frame with stainless steel screws
to avoid future mixed-metal corrosion problems with the steel framing.
For the type of house we were building, ideally none of the
windows should be able to be opened, since that would let in unconditioned,
unfiltered air from the outside. However, local building codes
require fire egress capability in the bedrooms, and we decided
to have a number of other windows be openable in case of a failure
of our ventilation system, or a kitchen grease fire or something
similar.
The architect had originally designed the windows to have 3"
wide frames around them on the outside. Unfortunately, neither
Milgard nor the siding manufacturer makes a trim piece that size.
In order to get the look that the architect had in mind, the trim
would have to have been custom made. As a cost-saving measure,
we decided not to do it. However, now that the house is done,
we can see that it really would have looked much better to have
the wider trim.
The exterior doors were also installed at about this time.
The doors are made of aluminum, with large glass panes. We had
a difficult time finding a reasonably priced metal door. One brand
that we looked at was over $1,000 per door, unpainted and without
glass. The ones we ended up using were made by Blomberg
Doors. Like the windows, they are painted with a factory-applied
baked-on white paint. They also come from the factory with a handle,
lockset, hinges and trim. They are very attractive, and they nicely
complement the Milguard windows. They were installed in a way
similar to the windows, with a bead of 100% silicone caulk around
the perimeter to form an airtight seal.
The interior doors are solid maple. We chose a 2-panel style.
They were custom made for us, using only standard yellow wood
glue. We had some difficulty locating a durable, non-toxic finish
for the doors. We finally decided on Crystal Aire, which is made
by Pace Chem. This product is very smelly and toxic while it's
being applied. However, it dries fast, and is completely non-toxic
and odor-free afterwards. To make sure that the fumes weren't
absorbed into the walls of the house, we had the doors finished
in the garage, with maximum ventilation.
You might enjoy the following book about doors, from
Amazon.com:
